Ponytail Hat

Ponytail hat

I call this the Ponytail Hat because, well it looks like the hat has a ponytail 🙂  Not suitable for wearing with actual ponytails, although I suppose you could modify it.  It is youth sized (my head is 20 inches in circumference without hair which is very small for an adult, more like pre-teen sizing).

This hat was made on the Knifty Knitter long yellow loom knittiing in the round.  I used a “ruffled” cast on (not that it looks very ruffled), then a K1P1 ribbing for six rows.  Next was ten rows of e-wrap and then I started the decreasing: first just the end pegs and then four pegs per row until I had eight pegs left.  I knitted the tube at eight pegs for about four inches, then decreased to six pegs for about five rows and then down to four pegs for the remainder of the ponytail.  Add fringe and voila!

This used most of one skein of Colinette Marshmallow in the Lagoon colourway.  To do an adult hat I’d go up to the green long loom and it would probably take one and half skeins. (It’s actually a little short for me as it is, if I were to do it again for myself I’d add 3-4 more rows of e-wrap but that would have put me over one skein and I didn’t have any more.)

“Sampler 6” Fingerless Gloves


I designed these gloves for two reasons: One, as a sampler of various stitch patterns that you can do on the round looms and Two, because I hadn’t seen any gloves done in the round, only flat panels that were seamed up.

I have a small hand and wrist, but I wanted to be able to wear these over my wrist braces. They stretch a fair bit. The pic below is NOT over braces. I also wanted the cuff to be loose so that it can go over a shirt sleeve or even the bottom of a coat sleeve as I hate how the wind can get in there! So this has a wider, gauntlet-like cuff then it narrows at the wrist. The whole pattern is a little roomy, if you want it tighter use the flat knit instead of the e-wrap.

Each set of stitches is done in 6 rows, hence the 6 in the name 🙂 The pattern goes as follows:

On the Knifty Knitter Round Blue Loom: 6 rows of garter stitch (e-wrap odd rows, purl even rows); 6 rows of e-wrap; 6 rows of K2P2 ribbing (knit two with the flat stitch, purl two, all the way around the loom), 6 rows of e-wrap, 6 rows of e-wrap as a flat panel (do not connect! turn around at the last peg and go back, this makes the hole for the thumb), 6 rows of garter stitch (as above), 6 rows of K2P2 ribbing (as above).

I’m sorry, but if you don’t know how to do any of the above steps, you need to look it up, I don’t have time to explain.

I used the horrible yarn that came with the Reader’s Digest loom set. Man, that stuff splits and frizzes badly. I probably won’t keep these gloves long as I don’t think the yarn will last!

Next I am going to make some fingerless gloves just in the K2P2 ribbing, which will be much tighter. I find K2P2 very tedious, but it does give a lot more “compression” than anything else I have tried thus far. I may do a sampler of various types of ribbing (K1P1, K3P1, etc.) to compare.

Sampler 6 Fingerless Gloves Modelled

Ragdoll Hat

Ragdoll HatI created this hat in Mid-December. I was inspired by several Fraggle hats I have seen on the internet, but due to the thickness of the yarn it doesn’t really look like those. Instead, it reminds me of Raggedy Ann, and thus the name 🙂 It’s made of one skein (every last inch of it!) of Colinette Marshmallow in the Fiorentina colourway. I have a small head and no hair and thus the hat fits my 20″ head, but for an adult size you’d probably need more yarn if you want it to be double knit.I made a 12 inch/30 cm long rectangle by double knitting on the long pink Knifty Knitter loom with the figure 8 wrap. I used the lucet cast on. I then took the rest of the yarn and cut it into 6 inch/15 cm lengths and used those pieces to close up the sides, tying in square knots. If you wanted to make this for a larger head (most adults would need a larger size), I’d use the yellow loom and do more rows, but really you can make a long rectangle any way you fancy!It took an evening while watching TV, don’t know the exact timing. I’ve ordered three more skeins to make a matching scarf because I looooove this yarn!Ragdoll Hat Modeled